Germany's advanced technology is made from 100% recycled plastic made from high-density polyethylene, which is an environmentally friendly recyclable materials can be UV, anti-violent stamping. After the use of lawn coverage of 95%, load-bearing capacity of 200 t / m2, while it addresses the shortcomings of grass brick can be used for hot and dry regions grass grid specification is 41x41x5.0cm, two) grass grid construction methods: their construction methods and similar grass brick, specifically: ① original pit real, ② in accordance with the original soil surface load conditions do with the gravel parking 20cm ~ 30cm supporting layer, 2 ~ 3cm sand / sand mixture, ③ laying grass grid, ④ finally laying sod. Lined up a number of grass grid can also be arranged in a trapezoid. Each grass grid should stitching intact, as required by generic tools can be made into a curved or other shapes. Grass at the bottom of the grid can be staggered so that it is well fixed and installed on the ground. If necessary, the entire area can be framed with a fixed perimeter or nails (accessory) will be fixed, in order to avoid thermal expansion grass grid situations that may occur, must be reserved 1 ~ 1.5cm seam between each grass grid. Planting should be completed in two steps. ① first grassroots fill soil, ② and then sprinkling the soil, making it a solid, ③ then sprinkle grass seed or sod directly covered. ④ When sprinkle seeds should then sprinkled some soil to the grassroots level to the top soil and grass grid high. ⑤ During the seeds germinate, must often watering, do not travel on the newly planted sod, turf once fully grown, this area can be put into use.